Theory or What is it:
For the residents who live in high buildings, low water pressure is a very common problem, especially when many people use the water at the same time. Therefore, many people install a water tower on the roof of the building. The water is stored at a water tank at the basement first. Then it is pumped into the water tower on the roof using a pumping motor. In this manner, the low water pressure problem can be improved and the water can be used in a more efficient way.
The water level indicator is a device that indicates with signal of the level of water of the tank. This level is proportional to feedback of input device. This device is use as deeply water tank, large container and etc.
Required instrument:
1. Op_Amp (741) × 4
2. LED × 4
3. Resistance (2 kΩ × 5) & (220 Ω ×4)
4. DC source (10v×1) &(12v×2)
5. Ground
Procedure:
1. Firstly the circuit was designed on electronic workbench.
2. Then the value of R is the voltage of V divided by numbers of resistance R.
3. The output of all Op-amp by LED.
4. If Vin is zero then no light will ON and if we gradually increase Vin then the numbers of LED ON will increase. Because all Op_Amp will reach to +Vsat one by one and proportional to water level.
Simulation result:
We regarded from the simulation that, the Vin is decrease or level of water is low level then the BLUE LED is ON. If Vin is increase or level of water is medium level then the GREEN LED is ON. And if Vin is more increase or level of water is brimming then the RED LED is ON.
Conclusion:
In the circuit Vin is increase or level of water is medium level then the GREEN LED & BLUE LED is ON but there only GREEN LED will be ON. And if Vin is more increase or level of water is brimming then the all LED is ON but there only RED LED will be ON. This is the problem of designed circuit.


No comments:
Post a Comment